Cisco 200-301 Practice Test - Questions Answers, Page 88
Question list
List of questions
Related questions
Which signal frequency appears 60 times per minute?
1 Hz signal
1 GHz signal
60 Hz signal
60 GHz signal
What is a benefit of a point-to-point leased line?
flexibility of design
simplicity of configurator
low cost
full-mesh capability
Refer to the exhibit.
Rooter R1 is added to the network and configured with tie 10 0 0 64/26 and 10.0.20.0/24 subnets However traffic destined for the LAN on R3 is not access. Which command when executed on R1 defines a tunic route to reach the R3 LAN?
What is a function of the core and distribution layers in a collapsed-core architecture?
The router must use IPv4 and IPv6 addresses at Layer 3.
The core and distribution layers are deployed on two different devices to enable failover.
The router can support HSRP for Layer 2 redundancy in an IPv6 network.
The router operates on a single device or a redundant pair.
Refer to the exhibit.
Switch AccSw2 has just been added to the network along with PC2. All VLANs have been implemented on AccSw2. How must the ports on AccSw2 be configured to establish Layer 2 connectivity between PC1 and PC2?
Which device separates networks by security domains?
firewall
access point
intrusion protection system
wireless controller
Refer to the exhibit.
Router OldR is replacing another router on the network with the intention of having OldR and R2 exchange routes_ After the engineer applied the initial OSPF configuration: the routes were still missing on both devices. Which command sequence must be issued before the clear IP ospf process command is entered to enable the neighbor relationship?
Option A
Option B
Option C
Option D
What is a reason to implement LAG on a Cisco WLC?
Increase the available throughput on the link.
Increase security by encrypting management frames
Allow for stateful failover between WLCs
Enable the connected switch ports to use different Layer 2 configurations
What differentiates the Cisco OfficeExtend AP mode from FlexConnect AP mode?
FlexConnect allows a personal SSID to be configured on the AP, and personal SSIDs are not supported with OfficeExtend.
OfficeExtend does not support DTLS tunneling of traffic to the WLC, and FlexConnect tunnels traffic to the WLC with DTLS.
OfficeExtend tunnels all traffic through the WLC, and FlexConnect terminates client traffic at the AP switch port.
FlexConnect must be deployed behind a router that NATs the client traffic, and OfficeExtend uses public IP sources.
Refer to the exhibit.
Refer to the exhibit. The IPv6 address for the LAN segment on router R1 must be configured using the EUI-64 format. When configured which ipv6 address is produced by the router? O
2001:db8:1a44:41a4:C801:BEFF:FE4A:1
2001:db8:1a44:41a4:C081:BFFF:FE4A:1
2001:db8:1a44:41a4:4562:098F:FE36:1
2001:db8:1a44:41a4:C800:BAFE:FF00:1
Question