Cisco 200-301 Practice Test - Questions Answers, Page 36
Question list
List of questions
Related questions
Which JSON data type is an unordered set of attribute- value pairs?
array
string
object
Boolean
What is the expected outcome when an EUI-64 address is generated?
The seventh bit of the original MAC address of the interface is inverted
The interface ID is configured as a random 64-bit value
The characters FE80 are inserted at the beginning of the MAC address of the interface
The MAC address of the interface is used as the interface ID without modification
Which protocol prompts the Wireless LAN Controller to generate its own local web administration SSL certificate for GUI access?
HTTPS
RADIUS
TACACS+
HTTP
The SW1 interface g0/1 is in the down/down state. Which two configurations are valid reasons for the interface conditions?(choose two)
There is a duplex mismatch
There is a speed mismatch
There is a protocol mismatch
The interface is shut down
The interface is error-disabled
Which network plane is centralized and manages routing decisions?
policy plane
management plane
control plane
data plane
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?
configure a stateful DHCPv6 server on the network
enable SLAAC on an interface
disable the EUI-64 bit process
explicitly assign a link-local address
Refer to the exhibit.
Which command configures a floating static route to provide a backup to the primary link?
ip route 0.0.0.0 0.0.0.0 209.165.202.131
ip route 209.165.201.0 255.255.255.224 209.165.202.130
ip route 0.0.0.0 0.0.0.0 209.165.200.224
ip route 209.165.200.224 255.255.255.224 209.165.202.129 254
Which two QoS tools provides congestion management? ( Choose two )
CAR
CBWFQ
PQ
PBR
FRTS
Refer to the exhibit.
An access list is created to deny Telnet access from host PC-1 to RTR-1 and allow access from all other hosts A Telnet attempt from PC-2 gives this message:"% Connection refused by remote host" Without allowing Telnet access from
PC-1, which action must be taken to permit the traffic?
Add the access-list 10 permit any command to the configuration
Remove the access-class 10 in command from line vty 0.4.
Add the ip access-group 10 out command to interface g0/0.
Remove the password command from line vty 0 4.
An engineer must configure an OSPF neighbor relationship between router R1 and R3 The authentication configuration has been configured and the connecting interfaces are in the same 192.168 1.0/30 sublet. What are the next two steps to complete the configuration? (Choose two.)
configure the hello and dead timers to match on both sides
configure the same process ID for the router OSPF process
configure the same router ID on both routing processes
Configure the interfaces as OSPF active on both sides.
configure both interfaces with the same area ID
Question