Cisco 200-301 Practice Test - Questions Answers, Page 52
Question list
List of questions
Related questions
What is a function of a Next-Generation IPS?
makes forwarding decisions based on learned MAC addresses
serves as a controller within a controller-based network
integrates with a RADIUS server to enforce Layer 2 device authentication rules
correlates user activity with network events
Which characteristic differentiates the concept of authentication from authorization and accounting?
user-activity logging
service limitations
consumption-based billing
identity verification
Which value is the unique identifier that an access point uses to establish and maintain wireless connectivity to wireless network devices?
VLANID
SSID
RFID
WLANID
An engineer is configuring remote access to a router from IP subnet 10.139.58.0/28. The domain name, crypto keys, and SSH have been configured. Which configuration enables the traffic on the destination router?
Option A
Option B
Option C
Option D
Which QoS per-hop behavior changes the value of the ToS field in the IPv4 packet header?
shaping
classification
policing
marking
Refer to the exhibit.
Which route must be configured on R1 so that OSPF routing is used when OSPF is up. but the server is still reachable when OSPF goes down?
ip route 10.1.1.10 255.255.255.255 172.16.2.2 100
ip route 10.1.1.0 255.255.255.0 gi0/1 125
ip route 10.1.1.0 255.255.255.0 172.16.2.2 100
ip route 10.1.1.10 255.255.255.255 gi0/0 125
Refer to the exhibit.
Users need to connect to the wireless network with IEEE 802. 11r-compatible devices. The connection must be maintained as users travel between floors or to other areas in the building What must be the configuration of the connection?
Select the WPA Policy option with the CCKM option.
Disable AES encryption.
Enable Fast Transition and select the FT 802.1x option.
Enable Fast Transition and select the FT PSK option.
Refer to the exhibit.
What is a reason for poor performance on the network interface?
The interface is receiving excessive broadcast traffic.
The cable connection between the two devices is faulty.
The interface is operating at a different speed than the connected device.
The bandwidth setting of the interface is misconfigured
Refer to the exhibit.
A network engineer must update the configuration on Switch2 so that it sends LLDP packets every minute and the information sent via LLDP is refreshed every 3 minutes Which configuration must the engineer apply?
Refer to the exhibit.
Users on existing VLAN 100 can reach sites on the Internet. Which action must the administrator take to establish connectivity to the Internet for users in VLAN 200?
Define a NAT pool on the router.
Configure static NAT translations for VLAN 200.
Configure the ip nat outside command on another interface for VLAN 200.
Update the NAT_INSIDE_RANGES ACL
Question