Cisco 200-301 Practice Test - Questions Answers, Page 55

What are two benefits of FHRPs? (Choose two.)

Refer to the exhibit.

Which command configures OSPF on the point-to-point link between routers R1 and R2?

What causes a port to be placed in the err-disabled state?

Refer to the exhibit.

An engineer is configuring a new router on the network and applied this configuration. Which additional configuration allows the PC to obtain its IP address from a DHCP server?

Which Layer 2 switch function encapsulates packets for different VLANs so that the packets traverse the same port and maintain traffic separation between the VLANs?

Refer to the exhibit.

The following must be considered:

• SW1 is fully configured for all traffic

• The SW4 and SW9 links to SW1 have been configured

• The SW4 interface Gi0/1 and Gi0/0 on SW9 have been configured

• The remaining switches have had all VLANs added to their VLAN database

Which configuration establishes a successful ping from PC2 to PC7 without interruption to traffic flow between other PCs?

R1 as an NTP server must have:

• NTP authentication enabled

• NTP packets sourced from Interface loopback 0

• NTP stratum 2

• NTP packets only permitted to client IP 209.165 200 225

How should R1 be configured?

Refer to the exhibit.

Which two configurations must the engineer apply on this network so that R1 becomes the DR?

(Choose two.)

Which type of IPv6 address is similar to a unicast address but is assigned to multiple devices on the same network at the same time?