Cisco 200-301 Practice Test - Questions Answers, Page 44

List of questions
Question 431

A network engineer must create a diagram of a multivendor network. Which command must be configured on the Cisco devices so that the topology of the network can be mapped?
Question 432

What is the same for both copper and fiber interfaces when using SFP modules?
Question 433

When a WLAN with WPA2 PSK is configured in the Wireless LAN Controller GUI which format is supported?
Question 434

When deploying syslog, which severity level logs informational message?
Question 435

Refer to the exhibit.
What does router R1 use as its OSPF router-ID?
Question 436

Which protocol does an access point use to draw power from a connected switch?
Question 437

Refer to the exhibit.
To which device does Router1 send packets that are destined to host 10.10.13.165?
Question 438

Which networking function occurs on the data plane?
Question 439

Refer to the exhibit.
Only four switches are participating in the VLAN spanning-tree process.
Branch-1 priority 614440
Branch-2: priority 39082416
Branch-3: priority 0
Branch-4: root primary
Which switch becomes the permanent root bridge for VLAN 5?
Question 440

Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
Question